The CMOS RAM is powered by the onboard button cell battery. To clear the RTC data:

(1) Turn off your computer

(2) Place the jumper cap onto the pinpair 2-3 at least 6 seconds to clear CMOS

(3) Place the jumper cap onto the pinpair 1-2 to Normal

(4) Turn on your computer until CMOS checksum error appears

(5) Hold down the Delete key when boots

(6) Enter the BIOS Setup to re-enter user preferences.

Clear Password: CLP

This jumper allows you to enable or disable the password configuration. You may need to enable it if you forget your password. To clear the password setting:

(1) Turn off your computer

(2) Place the jumper cap onto pinpair

(3) Turn on your computer

(4) Hold down the Delete key during bootup and enter BIOS Setup to clear password

(5) Save the setting and exit

(6) Turn off your computer.

FSB Frequency Select: FSB

This jumper allows you to select the front side bus frequency of the board.